Hi All
We started the project this summer at Paul Neese's Street Rod Welding & Fabrication in Hurst, TX.  A set of American Stamping rails were used with an 8" Ford rear-end.  It will run a 283 cu.in. Chevy V-8 with a Powerglide or possibly a '48 Merc flat motor if I'm able to acquire it.  An old dropped axle which will be drilled with split wishbones front and rear.  We have a floor in it now and ready to whack the top.  Will have to brace the "B" pillars first and install bear claw door latches.  The car will get a '35 Chevy Std. Dash (with the instrument cluster in the center) really looks good, like it was made for it.  After a little "tweakin" of course.  I'm very excited about the project, since this will be my first real early Hot Rod.  So here's a few before and after shots.  Dean