Larry Henderson 51 Henry J

Header__ARTICLEShorter




		Garage Shots of Larry Henderson”s 51 Henry J Page 2

			Click on Photos to enlarge

The rocker panels are being set in to allow for the door bottoms to be lengthened down to the bottom of the rocker panels to eliminate the horizontal line that would normally be at the bottom of each door.

It takes away that horizontal line and looks a lot cleaner.

Here are a couple more shots of the concealed rocker panels.

This side is almost complete, and the horizontal line is gone.

Just a couple shots of the work being done to close up the gaps between the hood and the front fenders.

A lot more work than it looks like in the pictures. Both fenders had to be pie cut along the hood and metal added to them to make the gaps more uniform.

Here are some pics of the new Hagan door hinges installed.

SPW power windows being installed.

Moving closer to going to body and paint

Here are pics of some of the interior work that is being done. This is a lot of work but the results will be more than worth it.

The door panels and roof lines are being re-worked to receive paint in some areas and provide a place for headliner and door panel upholstery to terminate at others.

Not too far from going to body and paint prep

Here are 4 more pics of some of the interior modifications taking place.

It may not look like a lot of work but it takes a lot of time to fill in and smooth out all the lines inside around the windows and doors to make everything flow together.

Here are 4 pics of some of the clean up work going on under the rear area of the car at the wheel wells and rear roll pan.

Here are a couple pics of work currently being done. Speaker installation both front and rear, with remainder of components to be in the trunk area

shot of it rolled outside.

windshield wiper motor etc. installation,.

MSD ignition module, and wiring harness location

few pics of the hand made hood trim shaped from aluminum and will be chromed later

a passenger side shot also.

A few pics of recent work:
Front rotors and brakes. Working toward a completion date of early 2009.

electric & manual trunk release

trunk area being enclosed

handmade hood trim pieces

3 pods, large one for GPS navigation system, one for satellite radio antenna, one for GPS Haneline Gauges

and the most important one the cup holder.

Here are some pics of the exhaust work being done.

A lot harder that it might look in these shots.

I stopped by the car this morning and took a few shots of the trim being made to go around both the inside and outside of the rear side windows.

It will be chrome plated when complete and will match the original chrome trim around the front and back windows.

Some more recent pics of work on the Henry J. Update December 11, 2008

Getting the underside of the car prepped for paint

as well as the frame

One off wheels by Evod Industries have arrived.

[2009 Show Coverage] [Barn & Field Cars] [Blast to the Past] [Book Reviews] [Build Articles] [Buyers Guide] [Classifieds] [Club Directory] [Event Listings] [From our Friends] [Garage Shots] [Guest Columnists] [www.hotrodhotline.com/md] [New Products] [Newsletter Archive] [Order a Catalog] [Our Heroes] [Press Releases] [Rodders Forum] [Rodders Row] [Shop Tours] [Vendor Directory] [Young Rodders] [Advertising Information] [Modern Rods]


	Copyright 1999 - 2009 Hot Rod Hot Line All Rights Reserved No Portion May Be Used Without Our Written Permission Contact Us Toll Free (877) 700-2468 (US) or (208) 562-0470 (Outside US) 230 S. Cole Rd, Boise, ID 83709