Once I was done stripping the body, I started on the fender skirts...that took some studying... I tried to adapt a pair of Ford Cruiser skirts, but I didn't like how far they stuck out away from the body...besides they were way too short...I set about to build a framework. Using 1/4" round rod, 1/2" tubing and some 14 gauge metal for the "tabs"-mounting points. I'm using six bolts to hold the skirt on...three in the wheel well, two on the bottom of the rear panel, where the original chrome trim bolted and one inside the wheel well, where the stock skirt was attached.
Copyright 1999 - 2011 Hot Rod Hot Line All Rights Reserved No Portion May Be Used Without Our Written Permission Contact Us Toll Free (877) 700-2468 (US) or (208) 562-0470 (Outside US) 230 S. Cole Rd, Boise, ID 83709