|
 |
|
|
|
|||
|
||||||
|
Installing HushMat in your doors. |
||||||
|
|
||||||||||||||||||||||||||||||||||||||||||||||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Position the sheet against the outer door skin by using the smaller access holes through doorframe. Cover a minimum of 70% of the door skin starting in the center and work toward the outer edges of the door. This treatment will reduce the vibration of the thin outer door metal. |
|||||||||||||
 |
|||||||||||||
|
Starting on one edge of the doorframe, peel back the brown release paper from the 12 X 23 sheet of HushMat Ultra. Apply the material from the top of the frame to the bottom making sure to cover all access holes through the door. The HushMat Ultra also serves as the vapor barrier that you removed |
|||||||||||||
 |
|||||||||||||
|
Carefully cut access slits through the HushMat Ultra where wiring or door hardware must pass through. Pull wiring or hardware through the slits. |
|||||||||||||
 |
|||||||||||||
|
Reinstall door speaker and hardware to the door. |
|||||||||||||
 |
|||||||||||||
|
Lay the door panel on a table or flat surface with the back of the panel facing up. Lay one sheet of HushMat Silencer Megabond ΒΌ” foam against the door panel leaving the white release paper intact. Place the edge of the foam just inside the fasteners or clips that secure the panel to the door. |
|||||||||||||
 |
|||||||||||||
|
With a scissors or utility knife, cut away any excess foam hanging over the edge of the door panel. Using you hands, press the foam to the panel surface. |
|||||||||||||
 |
|||||||||||||
|
Starting at one straight edge peel back the white release paper from the sheet of the Megabond and press onto the straight edge of the door panel. Work around the outer edges of the door panel applying finger and hand pressure to the foam surface. |
|||||||||||||
 |
|||||||||||||
|
Using utility knife or scissors, cut around all panel fastening points - speaker grill, wire harness – wherever hardware will be attached. Slit the Megabond foam and pull devices through. |
|||||||||||||
 |
|||||||||||||
|
Secure all hardware and electrical connections from the door panel to the door and place the panel back onto the vehicle. Test each device to ensure function before securing the panel. Secure the door panel to the door and the door installation is complete. Repeat steps for each door in your vehicle. |
|||||||||||||
 |
|||||||||||||
|
This installation was done on a late model car, but the installation techniques are the same on your rod or muscle car . For more information you can see our online videos and further information at our website. |
|||||||||||||
|
|
|
IMPORTANT NOTICE: All content in the articles in this section are the property of the author of the article and all advice and instructions are intended to be just basic guidelines for the undertaking of any project, and not intended for use by individuals who are not experienced in the particular field. We advise that you contact the manufacturer of any product or tool you are using for complete instructions. We also advise you to always use the appropriate safety equipment for the tools and products you are using. Hotrodhotline.com and its contributors disclaim any responsibility for the consequences of using the articles or procedures described in any of the articles in this section and by using this site you agree to these terms. No portion of any of these articles may be used without the written permission of HotRodHotLine.com and the Author. |
|
|
|
||||
|
|
|
|
Hot Rod HotLine Links |
|
|
| [HOME] [Classifieds] [Show coverage] [Buyers Guide] [Vendor Directory] |
|
|
|
|
|
Copyright 2007 Hotrodhotline.com All Rights Reserved |
