LizardSkin® SuperPro Spray Gun Kit
The SuperPro spray gun kit provides exactly what’s needed for professionals and hobbyists to properly apply amazing LizardSkin® coatings Typical spray guns used for paint application are simply not engineered to handle the higher density of these high technology coatings. To help facilitate this process for builders and manufacturers, LizardSkin LLC is pleased to offer the proven quality of the SuperPro spray gun.

For Small Area Applications
Use standard one-quart cup supplied with spray gun. Cup should be filled directly after mixing the product.

For Large Area Applications
Use the “Super Pro” spray kit attachment hose set to siphon material directly out of the LizardSkin® container. To prepare spray gun:

• · Use wrench to remove pickup tube from bottom of the spray gun.
• · Attach 5/8” hose barb fitting to bottom of the spray gun and tighten snugly.
• · Slide hose over the fitting/metal standoff tube.
• · Using box cutter or knife, cut an “X” in center of plastic lid to accommodate tube. If desired, attach clamp to hose below lid to hold siphon tube to bottom of pail.
  
  Attach air hose to gun with quick connect fitting and adjust air pressure to 50-70 psi . (Air course must deliver minimum 5 CFM.) The orifice nozzle in front of spray gun adjusts feed rate and spray pattern. Tightening the nozzle will reduce flow of material; loosening will increase flow. Increased flow may require additional air flow/pressure. Test spray prior to applying
  
  Tips For Best Results: Higher air pressure produces a finer pattern, but pressures over 100 psi may prematurely dry and damage the coating as it is being applied. Spray LizardSkin® evenly holding gun 6-9” away from surface. Avoid runs. It is best to spray a light tack coat and allow to set before building thickness with additional coats. LizardSkin® dulls as it dries. Test dryness by placing thumb on coating and turning 90°. If coating sticks, additional drying time is needed. Preferred wet thickness is 0.010-015” (10-15 mils or 0.25-0.5mm).
  
  Clean Up IMMEDIATELY
  When full coat is applied, pull tube and hose out of material bucket and immediately place in bucket of clean water, triggering until spraying clean water. Remove nozzle/orifice assembly and clean gun and nozzle with soap and water.
  
  Drying Time
  Additional coats may be applied after 20 minutes or when surface is dry to the touch. (Use thumb test as described above.) Drying time is dependant on ambient and surface temperatures. The hotter the surface or ambient temperature, the faster the dry time. Before sanding or other finishing, allow to cure 24 hours at 70º F. or higher. Do not apply LizardSkin® at temperatures below 70º F.
  
  Coverage
  One gallon of LizardSkin® SC - Sound Control Formula will cover 50 sq. ft. at a thickness of .020” wet thickness on flat surfaces.

to order LizardSkin® products go online at www.lizardskin.com or call 1 (877) 278-9468

Copyright 1999 - 2006 Hot Rod Hot Line All Rights Reserved
No Portion May Be Used Without Our Written Permission
Contact Us Toll Free (877) 700-2468 (US) or (208) 562-0470 (Outside US)
230 S. Cole Rd, Boise, ID 83709