|
Booster bracket & pedal kit WITHOUT the pedal pad mounting kit #12920. The bracket is designed to work with the Horton Hot Rod Parts' WS13200 frame center section. It indexes from, and welds to, the front upper tube, the lower center tube, and the frame rail boxing plate. The booster mounts under the floor further back on the frame rail. A 5/8" diameter tube connects the pedal to the booster (This tube might need to be cut to length and threaded 3/8-24 to suit your application). This set-up gives added clearance beside the transmission so the exhaust can be routed higher. The offset brake pedal arm mounts in double shear for extra strength. This also makes it easy to remove the pedal because it drops down from the bracket rather than having to slide it off of a pin. The pedal arm bracket bolts to 2 tabs welded to the frame rail boxing plate. This makes it easy to paint the bracket and the frame rail. The booster bracket is also set up for either a Ford or a GM manual master cylinder, if preferred. (If a manual master is used, order a 5.75:1 pedal arm, #20264 plunger rod, and a N06FRJZ jam nut instead of the parts noted below.) The bracket will mount either 7" (single or dual) or 8" dual boosters. Booster mounting holes are 3-3/8" x 3-3/8". WS12100
The pedal mount, items 3 and 10 (Part #’s 11802 and 11804) are pictured welded. The pedal arm, items 4 & 11 (Part #'s 213211 and 10092) are pictured welded. Please note: These items are sold NOT welded.
Parts included:
Listed by Photo Ref.# (if applic.): Description, Part #, Quantity Required
1: Plate, booster/master cylinder mount, formed, 11902, 1
2: Bushing for pedal pivot, Delrin, 20267, 2
3: Plate, pedal frame mount brkt; upper; formed, 11802, 1
4: Brake pedal arm, formed, 4.5:1, 213211, 1
5: Plate, pedal frame mount tab,11805, 2
6: Plate, formed pedal mount, NOT INCLUDED
7: Plate, formed pedal mount, NOT INCLUDED
8: Rod end; 3/8 male RH, CM-06, 1
9: Brake plunger tube; 22 in long,12101, 1
10: Plate, pedal frame mount brkt; lower, formed,11804, 1
11: Tube for 2067 Delrin bushing,10092, 1
Bolt, button head, SS 3/8-16x1-1/4, 370-423, NOT INCLUDED
Bolt, 3/8-16 RH 1 GR 5 Hex, zinc plated, B06CR1G5HZ, 4
Bolt, 3/8-16RH 1-1/2 GR 5 Hex, zinc plated, B06CR1.5G5HZ, 1
Bolt, 3/8-16RH 2-1/2 GR 5 Hex, zinc plated, B06CR2.5G5HZ, 1
Nut, 3/8-16;SS, NOT INCLUDED
Nut, 3/8-16 RH nylok, zinc plated, N06CRNZ, 6
Nut, 3/8-24 RH jam, zinc plated, N06FRJZ, 2
Washer, 3/8 SAE, zinc plated, W06SZ, 12
Washer, 3/8, internal tooth, SS NOT INCLUDED
|
