VIP Sponsors


Tip for Flex lines from Welder Series

Flex Line TipĀ  fromĀ  Welder Series

I used these little front panhard tabs (Welder Series part #219445) to hold the front section of my rear flex lines. I drilled them out to one little size smaller than 7/16", which is a press-fit for the -3 end of the hose. This way I don't have to use those clips and a bulkhead fitting. I've got a -3 joiner between the hard line and the flex line.



Welder Series has many really nice bracket and kits Check out their website for details on all of their parts.

Hotrod MD Category: