At that point, I trimmed out a sheet metal ‘pan’ to fit in front of the radiator, then I made some new metal side pieces and welded them alongside my radiator support…that done, I made some cardboard templates so I could bend up some side pieces out of sheet metal to cover the frame rails and steering box…I clamped a pipe into the vise and Dan (my bro) and I hand bent the two pieces around the pipe so it’d have a nice curve to them. I welded in a couple of bungs on each and used some button head bolts to hold them in.
Copyright 1999 - 2011 Hot Rod Hot Line All Rights Reserved No Portion May Be Used Without Our Written Permission Contact Us Toll Free (877) 700-2468 (US) or (208) 562-0470 (Outside US) 230 S. Cole Rd, Boise, ID 83709