HotRod_MD

RESOURCES:

 

 

Chassis and Frame

What Kind of Welder Should I Use ?   Article by  Welder Series

Make Your Own IFS Using Mustang Geometry    Article by Welder Series

Motor Mount Tech Tips   Article by Welder Series

SBC  Motor Mount Installation   Article by Welder Series

Subframe Installation .. article from Heidts

IFS Installation   article from Heidts 

Boxing a Frame   Article by Jim Clark

Reproduction Frames

X Members


IMPORTANT NOTICE: All content in the articles in this section are the property of the author of the article and all advice and instructions are intended to be just basic guidelines for the undertaking of any project, and not intended for use by individuals who are not experienced in the particular field. We advise that you contact the manufacturer of any product or tool you are using for complete instructions. We also advise you to always use the appropriate safety equipment for the tools and products you are using. Hotrodhotline.com and its contributors disclaim any responsibility for the consequences of using the articles or procedures described in any of the articles in this section and by using this site you agree to these terms. No portion of any of these articles may be used without the written permission of HotRodHotLine.com and the Author.

Copyright 2007-2011  Hotrodhotline.com   All Rights Reserved
No Portion may be used without our written permission
Contact Us:    877-700-2468   or   208-562-0470
230 S. Cole Rd, Boise, ID  83709