HotRod_MD

RESOURCES:

     F 100 Brakes for Early Fords      by Jim Clark

F-100 Brakes-7

 Stock bearing is on the left; ground bearing with the new radius is on the right.
 

F-100 Brakes-8

 Shown here is the finished swap minus the drum.

F-100 Brakes-9a
F-100 Brakes-10
F-100 Brakes-11

F-100 drum has a relatively flat wheel mounting surface allowing the wheels to fit over the drum rather than creating the drastic offset seen when small wheels are mounted on many other front brake conversions.

Click Here to go back to Brake Menu Page


IMPORTANT NOTICE: All content in the articles in this section are the property of the author of the article and all advice and instructions are intended to be just basic guidelines for the undertaking of any project, and not intended for use by individuals who are not experienced in the particular field. We advise that you contact the manufacturer of any product or tool you are using for complete instructions. We also advise you to always use the appropriate safety equipment for the tools and products you are using. Hotrodhotline.com and its contributors disclaim any responsibility for the consequences of using the articles or procedures described in any of the articles in this section and by using this site you agree to these terms. No portion of any of these articles may be used without the written permission of HotRodHotLine.com and the Author.

Copyright 2007-2011  Hotrodhotline.com   All Rights Reserved
No Portion may be used without our written permission
Contact Us:    877-700-2468   or   208-562-0470
230 S. Cole Rd, Boise, ID  83709