HotRod_MD

RESOURCES:

 

 

Flex Line Tip  from  Welder Series

     I used these little front panhard tabs (Welder Series part #219445) to hold the front section of my rear flex lines. I drilled them out to one little size smaller than 7/16", which is a press-fit for the -3 end of the hose. This way I don't have to use those clips and a bulkhead fitting. I've got a -3 joiner between the hard line and the flex line.

18bf7cc
18bf7db

 

Back to  Plumbing Menu


IMPORTANT NOTICE: All content in the articles in this section are the property of the author of the article and all advice and instructions are intended to be just basic guidelines for the undertaking of any project, and not intended for use by individuals who are not experienced in the particular field. We advise that you contact the manufacturer of any product or tool you are using for complete instructions. We also advise you to always use the appropriate safety equipment for the tools and products you are using. Hotrodhotline.com and its contributors disclaim any responsibility for the consequences of using the articles or procedures described in any of the articles in this section and by using this site you agree to these terms. No portion of any of these articles may be used without the written permission of HotRodHotLine.com and the Author.

Copyright 2007-2011  Hotrodhotline.com   All Rights Reserved
No Portion may be used without our written permission
Contact Us:    877-700-2468   or   208-562-0470
230 S. Cole Rd, Boise, ID  83709