You don't have to look any farther for tubular control arms for your hot rod. Full .120 wall, 1" diameter tubing, fixture welded and features screw-in ball joints and no-squeak bushings. These lower arms are designed to be used with strut rods and coil-over shocks. Will work with nearly any stock or aftermarket crossmember. Welding may be required on some applications.
Replaces 1974-80 Pinto, Bobcat and 1974-78 Mustang II control arms.
- Full .120" wall
- 1" diameter tubing
- 13-1/2" center to center and 6" at widest point
- 15-3/8" overall in length
- Weigh about 6-1/2 pounds (each arm)
- Pivot Point width: 3.380"
- Fixture welded
- Screw-in ball joints
- No-squeak bushings
- Works with Mustang II crossmembers that come without lower A-Arm tabs and require strut rods
- Designed to be used with coil-over shocks
-
Choose Left or Right side
Speedway Motors is your performance parts connection for carburetors, intake manifolds and fuel system components! Whether you need period-perfect vintage air cleaners for your Strombergs or linkage for that tri-power setup, Speedway has you covered. Or, go wild with a supercharger kit or dual quads atop a tunnel ram – all topped with a Shotgun Bill scoop! Don’t forget to feed your induction needs with a high-quality gas tank and performance fuel pump, too!
Just call 800.979.0122, or visit our website for more info. Speedway Motors is America’s Oldest Speed Shop® and has made street rodding safe, fun and affordable since 1952.